Shrink tube to protect your landing net handle from scratches. Landing net exclusive, 3m. Gamakatsu, Daiwa.

Thank you for viewing.

Thick-walled Shrink Tube for Landing Net Handles

Shrink tube, insulation tube, waterproof, highly flame-retardant, heat-shrink tubing.
Please use it as a cover for your landing net handle.
It prevents scratches and is highly recommended.
After trying various types, I settled on this shrink tube.

This is a thick-walled specification,
which further enhances its scratch-prevention effect.

Because it's thick, it might be a little difficult to slide onto the landing net handle at first,
but it becomes easy once you get the hang of it.
For the end point, please use vinyl tape to seal it and prevent water ingress.

If the cover gets damaged or dirty, simply replace it with a new one,
and your landing net handle will remain scratch-free.
(It won't get scratched even with moderate casting.)

Flat width: 55mm
Inner diameter: approx. 35mm
Length: 3m (This is enough for 2 landing net handles.)
Color: Clear (not perfectly transparent)
Thickness: 0.3mm
Shrink ratio: 2:1
Shrink temperature: 70℃
Fully shrink temperature: Max 110℃
Tensile strength: 10.4MPa

New

If you are unsure about installation,
please ask questions after purchase.
I will guide you through the process until it's done.

Thank you very much.

Photos 6 and 7 show the shrink tube after being used for over 30 rock fishing trips and then peeled off.
The landing net handle was kept in near-new condition.
I have also added photos after more than 50 uses, so please take a look.

Fishing type: Rock fishing